4pin 10mm Connector for IP20 RGB Strip

///4pin 10mm Connector for IP20 RGB Strip

4pin 10mm Connector for IP20 RGB Strip

  • One end for RGB extension wire and another end for RGB Non-waterproof strip light. Connect to wire without stripping insulation (insulation-piercing-contact)
  • DIY RGB connector wire with length you want, no more worry distance from strip light to Controller or power supply
  • As much as 5A ( R,G,B 3 channel ) supported, allow you to connect longer LED strip by one connector.
  • Strip light end can work with 10mm wide SMD5050 rgb strip light non-waterproof (Below 96LEDs/Meter), wire end can work with 4 conductor wire ranging 22~20AWG/0.34~0.54 mm2
  • Clear cap design will allow light to go through, will not leave dark area at your lighting space.

 

 

SKU: AC-SE-N10XB-4 Categories: ,

Description

NOTE: 1.Make sure your section of LED light strip is 10MM wide 4 PIN NON-WATERPROOF RGB LED Strip.
2 .Need to peel off the silicone on the surface of led light strip when you want to connect WATERPROOF LED strip.
3. Ensure your Wire Diameter 20-18AWG and without stripping wire .

Firmly bite through led light strip, don’t like traditional connector only conductive connection
Updated version of LED strip connector, assemble wire by yourself as needed, flexible to different project! Both solderless for rgb led strip and wire joint. Just clasp your prepared led strip section into the connector to get connected. worry-free solution for non-waterproof 5050 4pin LED light strip connection and extension needs,extension for whatever the wire length you want to connect.  compatible with 30-120 LEDs/M strip, made of flame retardant material, safely use. Support high current LED strip lights.
Solderless Wire Joint Quick Splice Connector for 20-18awg Cable  
Our products were an innovative safe and quick wire connector,peeling free,tapping free and twisting free. well waterproof and dust proof function. it greatly changes the way of wire connection .it allow any users to just insert the wire into wire joint and press cover by pliers to connect the wire safely and conveniently.
Installation Instructions: 
Strip End:  
1.Open the transparent cover of connector up to 90 degrees.
2 .Insert led strip section to the END of led strip connector, put the contact point of led strip on the PINS of the connector.
3. Close the transparent cap with a plier
Wire End :  
1.Cut the desired wire length and insert it directly into the guide slot.
2.Make sure that the positive & negative on the led strip light surface are corresponding to the ones on the wires.
3.Close the transparent cap with a plier.
4. End of installation.

more choices

 

Reviews

There are no reviews yet.

Be the first to review “4pin 10mm Connector for IP20 RGB Strip”