RGBW LED Connector 12mm IP20

///RGBW LED Connector 12mm IP20

RGBW LED Connector 12mm IP20

  • One end for RGBW extension wire and another end for RGBW Non-waterproof strip light. Connect to wire without stripping insulation (insulation-piercing-contact)
  • DIY RGBW connector wire with length you want, no more worry distance from strip light to Controller or power supply
  • As much as 5A ( R,G,B,W 4 channel ) supported, allow you to connect longer LED strip by one connector
  • Strip light end can work with 12mm wide SMD5050 rgbw (4 in 1) / RGB+White strip light non-waterproof (Below 90LEDs/Meter), wire end can work with 5 conductor wire ranging 22~20AWG/0.34~0.54 mm²
  • Clear cap design will allow light to go through, will not leave dark area at your lighting space

 

SKU: AC-SE-N12XB-5 Categories: ,

Description

RGBW LED Connector 12mm IP20

NOTE: Make sure your section of LED light strip is 12MM wide 5PIN NON-WATERPROOF LED Light Strip.

Firmly bite the strip, no need to peel back the silicon cover

Updated version of LED strip connectors, assemble wire by yourself as needed, flexible to different project! No need to solder. Just clasp your prepared led strip section into the connector to get connected. Connect waterproof LED strip without removing surface coating silicon gel, compatible with 30-60 LEDs/M strip, made of flame retardant material, safely use. Support high current LED strip lights.

Installation TIPS:

Strip End:

1. cut the strip straight perfectly, then fully open the clip.

2. push the strip in until it hits the backing, and pins on the connector make contact,and press hard down for several times with nose pliers to make sure the PINS puncture through the strips.

Wire End:

1. have to be separated the 5 wires before you insert them into the connector.

2. required to press down hard for several times with nose pliers! Ensure the contacts pierces through the insulation on the wire as there are so many non-standard wires on the market!

3. reminder: no stripping of the wires.  Just be sure polarity nodes are matched up “+” to  “+” and “-” to “-“.

more choices

 

Reviews

There are no reviews yet.

Be the first to review “RGBW LED Connector 12mm IP20”